| Official Luthiers Forum! http://www-.luthiersforum.com/forum/ |
|
| Glue cedar with CA???? http://www-.luthiersforum.com/forum/viewtopic.php?f=10102&t=1322 |
Page 1 of 1 |
| Author: | ejones [ Mon Mar 14, 2005 7:28 am ] |
| Post subject: | |
I chipped off a section of cedar kerfing and tried to glue it back on with thin CA. But the glue never set up. Is this a problem with cedar? With the thin CA? Do I need an accelerator? Maybe the gluing surface was too coarse. What's up? Eric P.S. I glued it back on with white glue. |
|
| Author: | Brock Poling [ Mon Mar 14, 2005 7:34 am ] |
| Post subject: | |
water thin CA? Maybe it is all soaking into the grain. Try shooting one side with a little accelerator and using a slightly thicker viscosity of CA. Also, make sure the pieces fit tight. |
|
| Page 1 of 1 | All times are UTC - 5 hours |
| Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |
|